[. . . ] Yellow To terminal always supplied with power regardless of ignition switch position. Before finally installing the unit, connect the wiring temporarily, making sure it is all connected up properly, and the unit and the system work properly. [. . . ] â· Refer to the owner's manual for details on connecting the other units, then make connections correctly. To protect the wiring, wrap adhesive tape around them where they lie against metal parts. â· Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails. Do not route wiring in places that get hot, such as near the heater outlet. If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body. â· Don't pass the yellow lead through a hole into the engine compartment to connect to the battery. This will damage the lead insulation and cause a very dangerous short. â· Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead. When replacing fuse, be sure to use only fuse of the rating prescribed on the fuse holder. To minimize noise locate the TV antenna cable, radio antenna cable and RCA cable as far away from each other as possible. Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function. [. . . ] Also, if the Head Unit's source is anything other than TV, channel changing and other independent operations are possible for the Rear Display. This Product RCA video output (Yellow) RCA audio output (White, Red) RCA cables (sold separately) To audio inputs To video input Display with RCA input jacks [. . . ]